Page 1 of 1

Wrapping PMF....

PostPosted: Fri Jan 31, 2020 11:09 am
by MJWBuffalo
So I decided on PMF after reading literally hundreds of pages here. I am satisfied that the process of painting "the mix" on the plywood, TBII, high quality canvas combined with lots of coats of good exterior paint and sanding can leave a lightweight, tough, waterproof surface that is also pretty smooth. I like that is gets me the desired result while going easy on the budget and being incredibly DIY friendly.

Here's the parts I haven't seen answered.... how much do I wrap? Like I understand that I overlap the corners and then wrap the roof down over the walls. But do I have also wrap inside the door and window openings? Can I wrap the whole thing in vinyl afterwards? Will it stick?

I am using my DIY Standie as a food trailer and will need some flashy graphics or at least a snazzy paint job that will help me stand out from the crowd



Re: Wrapping PMF....

PostPosted: Fri Jan 31, 2020 1:23 pm
by Pmullen503
Vinyl wrap works best on a smooth surface. It might stick to PMF finished with glossy paint but you should test to see if it looks the way you want.

Re: Wrapping PMF....

PostPosted: Sat Feb 01, 2020 1:20 am
by rjgimp
Yep. When in doubt, test it out! :D